Automotive Accessories

Tremec’s One-Off Manual C8 Corvette Shows the Cost of a Third Pedal

A track-built C8 with Tremec’s manual transaxle demonstrates feasibility, packaging compromises and a $75,000 gearbox price.

Mei-Lin ChenNovember 17, 20265 min read0 views

A conceptual view of a stripped, mid-engine race-car cockpit with a manual shifter and a cable running toward the rear transaxle on a private track.

Tremec has built a running manual-transmission version of the mid-engine Chevrolet Corvette C8 and allowed a test drive. The car is a one-off Peitz Performance race build, not a production model, but it demonstrates how a third pedal could be packaged into a platform that Chevrolet has offered only with a dual-clutch automatic.

The C8 marked two firsts for Corvette: a mid-mounted engine and an automatic-only transaxle. Developing two new transaxles—one manual and one automatic—was not in General Motors’ budget, according to the report. The decision favored comparison-test performance over the small group of buyers who wanted a manual. Tremec, whose six-speed has appeared in GM performance models including the Blackwings and Camaro, proceeded with its own C8 development car.

A track-only test bed

Tremec invited the reporter and several potential customers to Motorsports Gateway, a private track outside Howell, Michigan, to sample its transmissions. The manual C8 was a Peitz Performance race car with a fully caged interior and a harness. Fit and finish was essentially absent. The shifter rose from the space normally occupied by the storage cubby and automatic gear selector.

The seating position had virtually no adjustment. The author, who is 5-foot-7, could not reach the floor or brace properly in corners, making heel-toe downshifts awkward and limiting how hard the car could be pushed. The test took place on a green track on a November afternoon in Michigan.

Packaging and shift feel

Peitz did not have to make major changes to fit the gearbox. The tunnel was cut to install clutch-pedal hardware, but the manual transaxle otherwise sat where the stock dual-clutch unit would, without special mating hardware. The pedal box had enough room for a clutch and felt roomier than a previous-generation Camaro’s.

Because the shifter is remotely mounted, a cable runs rearward to the transaxle. That layout makes operation less precise and less “snick-snicky” than a front-engine TR-6060, and less notchy. Some drivers may prefer the smoother feel; others may miss the more mechanical sensation of the front-engine arrangement. The report frames that as a modest trade-off for getting a manual at all.

Cost remains the obstacle

The bigger obstacle is price. Tremec’s gearbox alone costs about $75,000, according to the report. Combined with the Corvette, a manual C8 build would rival a showroom-spec Z06. Tremec says the price should fall as volume rises. It also says OEMs are interested, not necessarily or exclusively GM. The gearbox was engineered to fit the C8, but other automakers have reportedly sought a high-torque manual transaxle; no customers were named.

The test car therefore proves feasibility rather than a showroom plan. It shows that a manual can fit the C8’s packaging and that the driving experience comes with compromises in shift feel and, for now, cost. Whether Chevrolet or another manufacturer commits to production remains unconfirmed.