Zeph Gage has built a rear-only portal-axle setup for his Jeep XJ using a Ford 9-inch axle housing, Humvee geared hubs, and HMMWV portal adapters from Jesse Haines Fabrication. The project stands out for its cost: the unit costs about one-fifth of the roughly $20,000 that a typical set of portal axles from companies such as 74Weld can command.
A rear portal without a full conversion
Portal axles use a gear stack at each driven wheel to raise the axle shafts and reduce the hardware hanging below the frame. That improves ground clearance and obstacle clearance, but conventional portal sets are expensive and complex. Two-gear portals, such as the Humvee design used here, also reverse the rotation of the input shaft.
To make the Ford 9-inch work with that rotation, Gage flipped the differential upside down so the driveline turns in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential. The arrangement effectively turns low-pinion parts into a budget high-pinion unit.
The conversion is not a complete portal-axle swap. Gage installed the portal only at the rear and kept the front solid axle. That approach, described as common in remote-control rock-crawler builds, avoids the packaging constraints that can arise when adding portal axles to a vehicle that never had them from the factory. It also allows full shock travel and keeps ride height from rising excessively.
Clearance gains and custom hardware
The setup adds six inches of clearance, retains full shock travel, and reduces stress on the differential. The rear end is intended to clear obstacles that the front can steer around rather than hang up on them. The resulting XJ can drive over a five-gallon bucket and still have several inches of clearance to spare.
The build required substantial custom work. Gage made brackets and custom-tapped plates, and used a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it includes an integrated electric emergency-brake solenoid and because it helps with clearance.
A deliberate front-rear compromise
Cost is the central appeal. A typical set of portal axles from companies such as 74Weld costs about $20,000, while the unit on Gage's Jeep costs a fifth of that. The rear-only layout also avoids some of the height and packaging penalties of a full conversion. It is not an off-the-shelf solution, however: the build relies on custom fabrication and a mix of Humvee-derived and Ford components.
For off-road use, the compromise is deliberate. Keeping the front axle solid preserves shock travel and packaging space, while the rear portal adds clearance where the vehicle is most likely to drag. Gage's build shows how a custom mix of geared hubs, a flipped differential and fabricated hardware can create a rear portal setup at a fraction of the usual price, while still requiring detailed work that keeps it far from bolt-on territory.
